METRAwin 10/MAVOLOG
Configuratie en uitlees software voor Mavolog
METRAwin for MAVOLOG 10 software is used for configuring parameters and visualizing data from the MAVOLOG 10. It includes the following functions:
- Configuration of device parameters (hook-up configuration, memory parameters)
- Memory mode initialization
- Read-out and print-out of complete statistics, as well as daily statistics
- Read-in and graphic representation of interval data
- Read-in and representation of events data in list format, as well as graphic representation of 10 ms RMS values from respective event curves
- Read-in and graphic representation of harmonics
- Online visualization of selected measured quantities
- Interval data or measurement series recorded on line are displayed at the monitor as a line diagram or a bar graph with horizontal time axis and can be analyzed with two pointers.
- The data logger display shows time and measured values numerically in an easy to read table, and allows for data export to other programs with the Windows clipboard.
- Event data read out from one or several MAVALOGs are listed in the order in which they occurred and can be printed as an events list.
- In the event of voltage dips, failure or swells, these are displayed in a time sequence which can be measured off with cursors. If the current signal is simultaneously available, conclusions may be drawn regarding the cause of the disturbances.
- Complete statistics and daily maximum values provide information concerning all important factors at a single glance.
- Parameters configuration for interconnected instruments as regards the measuring circuit, recording parameters, memory configuration etc., is accomplished by means of a menu-driven process.
- In the online mode, up to ten selectable measured quantities can be
scanned and recorded once every second.
System Requirements: Windows 98, 2000, XP, Vista, 7 (32/64bit)